GUIDE TO EAR TAPING

TAMPAX METHOD

Now that you have your new puppy, it is important you take proper care of the ears. Proper taping will ensure your puppy less stress and beautiful ears. It takes patience and persistence for success. Post your ears and leave them up six days, then take down and leave down for a few hours but remember, NEVER overnight. Re-tape and leave them up again for six days, then take down. When the ears stand, you can leave them down until they start to drop, then re-post as before and leave them another six days. Smell the ears regularly for scent of infection. NEVER post infected ears. Ear Taping the Doberman Pinscher You will need:

• 1 Doberman whose ears don't want to stand

• 2 Tampax (original or slender) for the posts (You can use paper towels rolled tightly)

• Cotton Balls (large size preferred)

• Cloth Tape (One inch width best)

• Scissors

• Alcohol (the rubbing kind, not the drinking kind)

• A helper ... always appreciated, definitely utilized

Step # 1: EAR PREPARATION

Clean the inside and outside of your Doberman's ears well with the alcohol. This is an extremely important step. A clean ear is far less likely to get infected and the alcohol removes the oil from the skin and makes the tape stick better. (NEVER, EVER USE HYDROGEN PEROXIDE ... it leaves the ears wet and infection can occur.) Clean the ears first so that when you get ready to post them the ears are good and dry.

Step # 2: MAKING THE POSTS

Tampax make perfect posts for Doberman pups as do Popsicle sticks tongue depressors or foam core. Cut two short pieces of tape, about 1-1/2 inches in length, and put to the side within easy reach. Take one of those pieces and tape across the top of the Tampon (the hollow end). This prevents the inner material from flying out when the puppy shakes his head (and embarrassing you in front of guests). Leave the paper on; It isn't necessary to remove the paper wrapping.

Unroll a large length of tape from the roll (you don't need to cut it) and place it sticky side out at the top of the post, angled slightly downward. Take your other short piece of tape and secure the long tape to the post. Wrap in a spiral action (like a barber's pole) all the way down the post, overlapping each layer a little to insure the post is completely covered, sticky-side out. Cut length off at the bottom to fit the post. Take a cotton ball (cut in half if you use large ones ... as I prefer) and pad the bottom of the post. Repeat with post # 2.

Step # 3: POSTING THE EARS

Pre-cut several strips of tape. Cut two approximately 3 inches long and two more approximately 5 inches long. Tack them on the edge of the table so they'll be handy. By now the pup has figured out something is amiss. Go get him out from under the bed (NEVER CALL HIM TO YOU ... Go get him. (Calling a dog to you to do something it doesn't like will result in a dog who won't ever come when called) Note the structure of the ear. See where it attaches at the top of the head? Notice the ear folds back a little in a natural fold. That is an important crease. It gives support to the ear. When you tape you need to be sure you tape this fold in place. Many try and wrap the ear forward to eliminate this fold. That is a mistake and will inhibit the progress of the ear standing. Hold the ear taut and taking care not to stick the ear to the post, place the post deep in the 'pocket' of the ear.

Pull the ear up tight ... I said TIGHT (yes, the pup will probably protest), and smooth and massage the ear firmly against the tape.
 
Holding the ear against the post to prevent it slipping, wrap one of the shorter pieces of tape around the top of the ear and post. DO NOT WRAP TOO TIGHTLY. It really isn't necessary to be tight, and doing so will cut off the blood circulation to the tip of the ear and that is BAD NEWS.

Next grab one of the longer pieces of tape and place just above where the post disappears into the ear and wrap back over the top of the head ... that is toward the center, around behind the ear and back toward the front. Make sure the ear crease is maintained and make sure the tape is not so tight as to impair circulation. Repeat the process with the other ear.

Step # 4: BRACING THE POSTED EARS

You'll need to prepare a brace to ‘stabilize' the posted ears. This is a must particularly on very active puppies. This is a step you can do beforehand, if you wish. If not, get someone to hold the puppy and restrain him from attempting to undo your handiwork while you make the brace.

Estimate the distance between the puppy's erect ears. Cut a long piece of tape, approximately 10 or 12 inches long.

About center, you'll want the Supporting brace that goes between the ears. Cut the tape half way at the points you deem are the outside edges of the support brace. Next trim away the top part of either side: Now fold the middle in half, sticky-side to sticky-side, to form a double thickness of tape ... that makes the middle support brace.

Next trim away the top part of either side:

Now fold the middle in half, sticky side to sticky side, to form a double thickness of tape ... that makes the middle support brace.

Now you have a strip of tape that is sticky on the end pieces and non-sticky in the middle.

Place the edge of the center brace about even with the center of the inside of the posted ear and wrap the brace tape around the post along the same path as the post's bottom piece of tape, and secure as tape length requires to the brace. Repeat with the other ear. Now take a couple of small strips from the pieces you cut off of the brace tape and wrap around the brace close to the ear to prevent the brace from pulling away from the posted ear ... repeat on other side.

Take talcum powder, BFI or Ayerst Eye & Wound Powder and lightly dust the exposed sticky post to prevent dirt, twigs and stuff from adhering to the post. You're done!

written courtesy of Tracy Pounds, Sunendei, USA submitted by Judy Bohnert, Canada

To Top  

GUIDE TO EAR TAPING - TAMPAX METHOD

Supplies:

• Sharp scissors

• Johnson and Johnson Zonas Tape

• Duct tape for covering the tampons  

• 2 cardboard tube Tampons per ear

• Skin Bond

• Popsicle sticks or tongue depressors  

Slip cardboard tube from one tampon over the other and slide the cotton out of the tube about 3/4 of an inch.

Take one piece of masking tape about 7" long cut or ripped into two pieces lengthwise. Then cut one of the pieces into two equal length pieces.

Place the long piece sticky side out on the flat side of the support folded under at each end . Take the two shorter pieces and wrap around the tube top and bottom to cover duct tape and hold tape in place.

Clean the dog's ear well with alcohol -- inside and out.

Put Skin Bond adhesive on the long piece of sticky tape.

Stretch and hold ear upright almost like it is pinned to a clothes line .

Place the prepared tampon firmly down into the ear canal, cotton side down, sticky, long tape towards the inside of the ear.

Cut three strips of one or two inch Zonas tape, one about 3 ", one about 4 " and one 5 "

Wrap the smallest piece on the top, middle size piece for the middle and longest piece for the bottom.

BE SURE that the natural fold on the ear (the part at the front of the ear that is rolled over ) stays rolled over.

If your pups ear needs a bridge or a brace then add it between the ears leaving enough slack to give the pup room to exercise its ears.

Home